Heater Relay Circuit
Circuit diagnosis · Vehicles built from Aug 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The heater relay is turned on by signals from the air conditioning amplifier assembly. The heater relay supplies power to the blower motor control.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. INSPECT HEATER RELAY (HTR) |
 |
- Remove the HTR relay from the driver side junction block assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
3 - 4
|
Battery voltage is not applied to terminals 1 and 2
|
Below 1 Ω
|
3 - 5
|
10 kΩ or higher
|
3 - 4
|
Battery voltage is applied to terminals 1 and 2
|
10 kΩ or higher
|
3 - 5
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (HTR RELAY - AIR CONDITIONING AMPLIFIER, BATTERY AND BODY GROUND) |
 |
Remove the HTR relay from the driver side junction block assembly (Click here).
Disconnect the A44 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
HTR relay terminal 2 - A44-14 (HR)
|
Always
|
Below 1 Ω
|
HTR relay terminal 2 - Body ground
|
Always
|
10 kΩ or higher
|
HTR relay terminal 3 - Body ground
|
Always
|
10 kΩ or higher
|
HTR relay terminal 4 - Body ground
|
Always
|
Below 1 Ω
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
HTR relay terminal 1 - Body ground
|
Ignition switch ON
|
11 to 14 V
|
Ignition switch off
|
Below 1 V
|
HTR relay terminal 5 - Body ground
|
Always
|
11 to 14 V
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 3. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY |
 |
- Remove the air conditioning amplifier assembly with its connectors still connected (Click here).
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
A44-14 (HR) - Body ground
|
- Ignition switch off
- Blower switch off
|
Below 1 V
|
- Ignition switch ON
- Blower switch on (LO level)
|
Below 1 V
|
- Ignition switch ON
- Blower switch off
|
11 to 14 V
|
Text in Illustration
*a
|
Component with harness connected (Air Conditioning Amplifier Assembly)
|
|
NG |
 |
|
| REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|