2014 Hilux · Service Manual SECURITIES

Ignition Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the ignition switch assembly is turned ON, voltage is applied to terminal IG of the theft warning ECU assembly.

WIRING DIAGRAM

B287100E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT IGNITION SWITCH ASSEMBLY

  1. B275965E01
    Remove the ignition switch assembly.
    1. for 1KD-FTV: Click here
    2. for 2KD-FTV: Click here
    3. for 1TR-FE: Click here
    4. for 2TR-FE: Click here
    5. for 1GR-FE: Click here

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (IG1) - 4 (AM1)
    Off, ACC
    10 kΩ or higher
    1 (IG1) - 4 (AM1)
    ON, Start
    Below 1 Ω

HINT:
If replacing the ignition switch assembly, refer to the procedures below.
  1. for 1KD-FTV: Click here
  2. for 2KD-FTV: Click here
  3. for 1TR-FE: Click here
  4. for 2TR-FE: Click here
  5. for 1GR-FE: Click here



NG
REPLACE IGNITION SWITCH ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (THEFT WARNING ECU - BATTERY AND BODY GROUND)

  1. B287082E01
    Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.
    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T36-1 (E) - Body ground
    Always
    Below 1 Ω
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    T39-1 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    except 2 Step Unlock Function:
    Tester Connection
    Switch Condition
    Specified Condition
    T36-18 (IG) - Body ground
    Ignition switch off
    Below 1 V
    T36-18 (IG) - Body ground
    Ignition switch ON
    11 to 14 V
    for 2 Step Unlock Function:
    Tester Connection
    Switch Condition
    Specified Condition
    T39-4 (IG) - Body ground
    Ignition switch off
    Below 1 V
    T39-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*A
except 2 Step Unlock Function
*B
for 2 Step Unlock Function
*a
Front view of wire harness connector
(to Theft Warning ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Security Horn Circuit (from Jun 2011)Security Indicator Light Circuit (from Jun 2011) →