2014 Hilux · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

When the theft deterrent system is in the disarmed state, the security indicator light assembly will flash continuously if the engine immobiliser system is set, or not illuminate if the engine immobiliser system is not set*.
When the theft deterrent system is in the armed state, the engine immobiliser system is automatically set and the security indicator light assembly will flash continuously*.
When the theft deterrent system is in the arming preparation state or alarm sounding state, the theft warning ECU assembly causes the security indicator light assembly to illuminate.
  1. *: w/ Engine Immobiliser System

WIRING DIAGRAM

B287101E01

INSPECTION PROCEDURE


1. INSPECT SECURITY INDICATOR LIGHT ASSEMBLY
B275967
  1. Remove the security indicator light assembly.

  1. Apply battery voltage between the terminals of the indicator, and check the illumination of the security indicator.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Illuminates

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not illuminate.
    2. If the voltage is too low, the security indicator light assembly will not illuminate.



NG
REPLACE SECURITY INDICATOR LIGHT ASSEMBLY
OK


2. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - THEFT WARNING ECU AND BODY GROUND)
  1. Disconnect the S10 security indicator light assembly connector.

  1. Disconnect the T36*1 or T39 *2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    S10-2 - T36-27 (IND)
    Always
    Below 1 Ω
    S10-2 or T36-27 (IND) - Body ground
    Always
    10 kΩ or higher
    S10-1 - Body ground
    Always
    Below 1 Ω
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    S10-2 - T39-22 (IND)
    Always
    Below 1 Ω
    S10-2 or T39-22 (IND) - Body ground
    Always
    10 kΩ or higher
    S10-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Ignition Switch Circuit (from Jun 2011)Driver Side Door Courtesy Switch Circuit (from Jun 2011) →