2014 Hilux · Service Manual SECURITIES

Driver Side Door Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Jun 2011

DESCRIPTION

The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly (for Driver Side).

WIRING DIAGRAM

B287266E01

INSPECTION PROCEDURE


1. CHECK COMBINATION METER ASSEMBLY
  1. When the for Driver Side door is opened/closed, check that the indicator in the combination meter assembly operates normally.

    OK:
    Indicator operates normally.



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER - THEFT WARNING ECU)
  1. Disconnect the C25 combination meter assembly connector.

  1. Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.

    1. *1: except 2 Step Unlock Function
    2. *2: for 2 Step Unlock Function

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    except 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    C25-17 - T36-7 (CTY)
    Always
    Below 1 Ω
    C25-17 or T36-7 (CTY) - Body ground
    Always
    10 kΩ or higher
    for 2 Step Unlock Function:
    Tester Connection
    Condition
    Specified Condition
    C25-17 - T39-7 (CTY)
    Always
    Below 1 Ω
    C25-17 or T39-7 (CTY) - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    C25-17 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR DRIVER SIDE)

  1. B276106E01
    Remove the front door courtesy light switch assembly (for for Driver Side) (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - Body ground
    Not pushed (ON)
    Below 1 Ω
    1 - Body ground
    Pushed (OFF)
    10 kΩ or higher

    Text in Illustration 
    *a
    Not pushed (ON)
    *b
    Pushed (OFF)
    *c
    Body ground



NG
REPLACE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - FRONT DOOR COURTESY LIGHT SWITCH [FOR DRIVER SIDE])
  1. Disconnect the C25 combination meter assembly connector.

  1. Disconnect the D2 front door courtesy light switch assembly (for for Driver Side) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C25-16 - D2-1
    Always
    Below 1 Ω
    C25-16 or D2-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Security Indicator Light Circuit (from Jun 2011)Front Passenger Side Door Courtesy Switch Circuit (from Jun 2011) →