Front Passenger Side Door Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2011
DESCRIPTION
The theft warning ECU assembly detects the condition of the front door courtesy light switch assembly (for Front Passenger Side).WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY (FOR FRONT PASSENGER SIDE) |
Remove the front door courtesy light switch assembly (for Front Passenger Side) (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - Body ground
Not pushed (ON)
Below 1 Ω
1 - Body ground
Pushed (OFF)
10 kΩ or higher
Text in Illustration *a
Not pushed (ON)
*b
Pushed (OFF)
*c
Body ground
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (FRONT DOOR COURTESY LIGHT SWITCH [FOR FRONT PASSENGER SIDE] - THEFT WARNING ECU) |
Disconnect the D3 front door courtesy light switch assembly (for Front Passenger Side) connector.
Disconnect the T36*1 or T39*2 theft warning ECU assembly connector.
- *1: except 2 Step Unlock Function
- *2: for 2 Step Unlock Function
- *1: except 2 Step Unlock Function
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- except 2 Step Unlock Function:
Tester Connection
Condition
Specified Condition
D3-1 - T36-7 (CTY)
Always
Below 1 Ω
D3-1 or T36-7 (CTY) - Body ground
Always
10 kΩ or higher
- for 2 Step Unlock Function:
Tester Connection
Condition
Specified Condition
D3-1 - T39-7 (CTY)
Always
Below 1 Ω
D3-1 or T39-7 (CTY) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
