INSPECTION
Inspection · Vehicles built from Jun 2011
| INSPECT FUEL TEMPERATURE SENSOR |
Measure the resistance of the sensor.


- Standard resistance:
Tester Connection
Specified Condition
1 (E2) - 2 (THF)
2.21 to 2.69 kΩ at 20°C (68°F)
1 (E2) - 2 (THF)
0.287 to 0.349 kΩ at 80°C (176°F)
- NOTICE:
- If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the sensor.
| INSPECT INJECTION PUMP DELIVERY VALVE |
![]() ![]() |
- NOTICE:
- Do not touch the sliding surface of the delivery valves.
Pull up the valve and release it. Check that it sinks smoothly to the valve seat. If the operation is not as specified, replace the valve and valve seat as a set.
- HINT:
- Before using a new valve set, wash off the rust prevention compound with diesel fuel. Then rewash with diesel fuel and perform the above test.

