Power Heater Switch Circuit
Circuit diagnosis · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The power heater operates when the heater switch assembly is on and the following conditions are met:
- Ignition switch is ON.
- Air inlet control damper position is FRESH.
- Blower motor switch is in any position other than OFF.
- Air mix damper position is Max. HOT.
- Engine coolant temperature is below 65°C (149°F).
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT HEATER SWITCH ASSEMBLY |
 |
- Remove the heater switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Switch Condition
|
Specified Condition
|
4 - 1
|
Heater switch assembly on
|
Below 1 Ω
|
4 - 1
|
Heater switch assembly off
|
10 kΩ or higher
|
Apply battery voltage to the switch connector and check that the indicator light illuminates.
- OK:
Measurement Connection
|
Specified Condition
|
Battery positive (+) → Terminal 5
|
Indicator light illuminates
|
Battery negative (-) → Terminal 8
|
Text in Illustration
*1
|
Indicator Light
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK HARNESS AND CONNECTOR (HEATER SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND) |
 |
Disconnect the P21 heater switch assembly connector.
Disconnect the A43 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
P21-4 - A43-8 (HEAT)
|
Always
|
Below 1 Ω
|
P21-5 - A43-5 (SWIN)
|
P21-4 - Body ground
|
Always
|
10 kΩ or higher
|
P21-5 - Body ground
|
P21-1 - Body ground
|
Always
|
Below 1 Ω
|
P21-8 - Body ground
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|