2014 Hilux · Service Manual HEATER & AIR CONDITIONING SYSTEM

Power Heater Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

The power heater operates when the heater switch assembly is on and the following conditions are met:
  1. Ignition switch is ON.
  2. Air inlet control damper position is FRESH.
  3. Blower motor switch is in any position other than OFF.
  4. Air mix damper position is Max. HOT.
  5. Engine coolant temperature is below 65°C (149°F).

WIRING DIAGRAM

E231645E01

INSPECTION PROCEDURE


1. INSPECT HEATER SWITCH ASSEMBLY

  1. E231678E02
    Remove the heater switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Heater switch assembly on
    Below 1 Ω
    4 - 1
    Heater switch assembly off
    10 kΩ or higher

  1. Apply battery voltage to the switch connector and check that the indicator light illuminates.

    OK:
    Measurement Connection
    Specified Condition
    Battery positive (+) → Terminal 5
    Indicator light illuminates
    Battery negative (-) → Terminal 8

    Text in Illustration 
    *1
    Indicator Light



NG
REPLACE HEATER SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HEATER SWITCH - AIR CONDITIONING AMPLIFIER AND BODY GROUND)
  1. Disconnect the P21 heater switch assembly connector.

  1. Disconnect the A43 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    P21-4 - A43-8 (HEAT)
    Always
    Below 1 Ω
    P21-5 - A43-5 (SWIN)
    P21-4 - Body ground
    Always
    10 kΩ or higher
    P21-5 - Body ground
    P21-1 - Body ground
    Always
    Below 1 Ω
    P21-8 - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Power Heater Switch Circuit (Aug 2012 – Jul 2013)PTC Heater Circuit (Jun 2011 – Jul 2012) →