2014 Hilux · Service Manual TRANSMISSION

REPLACEMENT

Removal / installation · Vehicles built from Jun 2011


1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }


2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Remove the propeller with center bearing shaft (Click here).


3. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

D028697E01
  1. Using SST, remove the oil seal.


4. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL

C220519E01
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09309-37010  

    Standard oil seal depth:
    5.8 to 6.2 mm (0.229 to 0.244 in.)

    NOTICE:
    Be careful not to damage the lip of the oil seal.


5. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Install the propeller with center bearing shaft (Click here).


6. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF Type T-IV


7. CHECK AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid (Click here).

← COMPONENTS (from Jun 2011)COMPONENTS (from Jun 2011) →