Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013
DESCRIPTION
The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio and display receiver assembly through this circuit.The sound signal that has been sent is amplified by the radio and display receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - STEREO JACK ADAPTER) |
Disconnect the R21 and R24 radio and display receiver assembly connectors.
Disconnect the N4 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R21-28 (VAL+) - N4-6 (ALO)
Always
Below 1 Ω
R21-26 (VAR+) - N4-5 (ARO)
R21-27 (VA-) - N4-7 (ASGN)
R21-11 (AGND) - N4-9 (AGND)
R21-25 (ADPG) - N4-8 (AUXO)
R24-2 (US1-) - N4-2 (UDO-)
R24-3 (US1+) - N4-3 (UDO+)
R21-28 (VAL+) - Body ground
Always
10 kΩ or higher
R21-26 (VAR+) - Body ground
R21-27 (VA-) - Body ground
R21-11 (AGND) - Body ground
R21-25 (ADPG) - Body ground
R24-2 (US1-) - Body ground
R24-3 (US1+) - Body ground
|
|
||||
| OK | ||
| ||
