C1436 Yaw Rate Sensor Malfunction
Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013
Versions by build date: Jun 2011 – Oct 2011 Nov 2011 – Mar 2012 Apr 2012 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor assembly via the CAN communication system.If there is trouble in the bus lines between the yaw rate sensor assembly and the CAN communication system, DTCs U0123 (Lost Communication with Yaw Rate Sensor Module) and U0124 (Lost Communication with Lateral Acceleration Sensor Module) are stored.
DTC C1436 is also stored when calibration is not completed.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1436 |
Either condition is met:
|
Yaw rate sensor assembly |
INSPECTION PROCEDURE
- NOTICE:
- After replacing the yaw rate sensor assembly, perform calibration (Click here).
- HINT:
- When DTC U0123 and/or U0124 is output together with DTC C1436, inspect and repair the trouble areas indicated by DTC U0123 and/or U0124 first (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR, YAW RATE SENSOR 2) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Yaw Rate Sensor
Yaw rate sensor / Min.: -128°/s, Max.: 127°/s
Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-
Yaw Rate Sensor2
Yaw rate sensor 2 / Min.: -128°/s, Max.: 127°/s
Vehicle stationary: 0°/s
Right turn: -128 to 0°/s
Left turn: 0 to 127°/s
-
Check the yaw rate sensor output value displayed on the intelligent tester.
Result Result
Proceed to
NG (Yaw rate sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning)
A
NG (Yaw rate sensor output value is not 0°/s when vehicle is stationary)
B
OK
C
- HINT:
- If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next suspected area (Click here).
|
|
||||
|
|
||||
| A | |
| 2. CHECK YAW RATE SENSOR ASSEMBLY INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate sensor assembly is installed properly (Click here).
- OK:
- The sensor is tightened to the specified torque.
- The sensor is not installed at an angle.
|
|
||||
| OK | ||
| ||
