2014 Hilux · Service Manual BRAKE

C1442 Invalid Data Received from Acceleration Sensor

Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013

Also covers:

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the yaw rate sensor via the CAN communication system.
The yaw rate sensor assembly has a built-in acceleration sensor and detects the vehicle condition.
DTC Code
DTC Detection Condition
Trouble Area
C1442
With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.
Acceleration sensor (Yaw rate sensor assembly)
C1443
With the IG1 terminal voltage between 9.5 and 17.4 V, an invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more.
Yaw rate sensor assembly

INSPECTION PROCEDURE

NOTICE:
After replacing the yaw rate sensor assembly, perform calibration (Click here).


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Start the engine and idle it for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)


← C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (Jun 2011 – Jul 2012)C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (from Aug 2013) →