2014 Hilux · Service Manual BRAKE

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. REMOVE CYLINDER BOOT

F043024
  1. Using a screwdriver, remove the 4 set rings and 4 seals from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE FRONT DISC BRAKE PISTON

C111364E02
  1. Prepare a wooden plate to hold the pistons.

  1. Place the wooden plate between the pistons and insert a pad on one side.

  1. F042677
    Use compressed air to remove the pistons one by one from the cylinder.

    CAUTION:
    Do not place your finger in front of the piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.


3. REMOVE PISTON SEAL

F042678
  1. Using a screwdriver, remove the 4 boots from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.


4. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.


5. REMOVE FRONT DISC BRAKE

C111383E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.

← REMOVAL (from Jun 2011)INSPECTION (from Jun 2011) →