2014 Hilux · Service Manual ENGINE

P2002 Particulate Trap Efficiency Below Threshold (Bank1)

Diagnostic trouble codes · Vehicles built Aug 2012 – Jul 2013

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

A244279E01

HINT:
  1. For more information on the Diesel Particulate Filter (DPF) catalytic converter, refer to the following procedures (Click here).
  2. If P2002 is present, refer to the DTC table for Diesel Particulate Filter System (Click here).

HINT:
The DPF catalyst has an ability to reduce particulate matter (PM), hydrocarbons (HC) and carbon monoxides (CO). The DPF catalyst is a monolithic type catalyst. Alternating passages in the catalyst have either their inlet or outlet blocked. This forces the exhaust gasses to flow through the walls of the passages (see illustration above). Due to the flow of the exhaust gasses through micro-cavities in the passage walls, it is called a "wall flow" type converter.

P2002 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
-
The Catalyst Record exceeds the threshold (Thermal deterioration malfunction)
(1 trip detection logic).
Front exhaust pipe assembly (DPF catalytic converter)
Related Data List 
DTC No.
Data List
P2002
DPF Thermal Deteriorate

MONITOR DESCRIPTION

In order to detect abnormality in the DPF catalytic converter, the ECM monitors the exhaust gas temperature as well as differential pressure in front of and behind the DPF catalyst.
Thermal deterioration malfunction
  1. Furthermore, the ECM calculates and integrates the Catalyst Record of catalyst thermal deterioration data with the catalyst temperature. If Catalyst Record exceeds the threshold, the ECM interprets this as a malfunction in the DPF catalyst and illuminates the MIL.
A193875E02

INSPECTION PROCEDURE

NOTICE:
  1. After replacing the DPF catalyst, clear the thermal deterioration data stored in the ECM.
  2. Inspect the fuses of circuits related to this system before performing the following inspection procedure.
  3. After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
  4. After replacing the fuel supply pump assembly, the ECM needs initialization (Click here).
  5. After replacing an injector assembly, the ECM needs registration (Click here).

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. REPLACE FRONT EXHAUST PIPE ASSEMBLY

HINT:
When the front exhaust pipe assembly is replaced, the catalyst record of DPF thermal deterioration stored in the ECM must be cleared.

  1. Replace the front exhaust pipe assembly (Click here).


NEXT


2. CATALYST RECORD CLEAR
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the menu options in this order: Powertrain / Engine and ECT / Utility / Catalyst Record Clear.


NEXT

END


← P2002 Particulate Trap Efficiency Below Threshold (Bank1) (Jun 2011 – Jul 2012)P2002 Particulate Trap Efficiency Below Threshold (Bank1) (Aug 2013 – Jul 2014) →