CB-13 USB Over Current Detection
Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012
Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| CB-13 |
An "iPod" or USB device overcurrent malfunction |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- The data stored on the USB device or "iPod" may be changed or lost due to malfunctions, repairs, system errors, etc. Therefore, when repairs are to be performed, explain this to the customer and obtain their consent prior to performing repairs.
| 1. REPLACE USB DEVICE OR "iPod" |
Disconnect the USB device or "iPod" from the stereo jack adapter assembly.
Turn the ignition switch off.
- HINT:
- When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.
Turn the ignition switch to ACC.
Connect a known good USB device or "iPod" to the stereo jack adapter assembly.
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs and check if the same DTC occurs again.
- HINT:
- If DTCs are output frequently, replace the radio receiver assembly.
- OK:
- Malfunction disappears.
|
|
||||
| OK | ||
| ||
| 3. CHECK RADIO RECEIVER ASSEMBLY |
Disconnect the N4 No. 1 stereo jack adapter assembly connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
N4-1 (UPI) - N4-4 (UJSG)
Always
4.5 to 5.5 V
Text in Illustration *a
Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)
|
|
||||
| OK | ||
| ||
| 4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO JACK ADAPTER) |
Disconnect the R20 radio receiver assembly connector.
Disconnect the N4 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R20-1 (USV1) - N4-1 (UPI)
Always
Below 1 Ω
R20-4 (UGD1) - N4-4 (UJSG)
Always
Below 1 Ω
R20-1 (USV1) - Body ground
Always
10 kΩ or higher
R20-4 (UGD1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
