2014 Hilux · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jun 2011


INSPECT MAP LIGHT ASSEMBLY (w/ Courtesy Light)

  1. E224853E07
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 - 10
    Spot light switch off
    10 kΩ or higher
    Spot light switch on
    Below 1 Ω
    7 - 6 (CTY)
    Not door position
    10 kΩ or higher
    Door position
    Below 1 Ω

    If the result is not as specified, replace the map light assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Map Light Assembly)

← REMOVAL (from Jun 2011)INSTALLATION (from Jun 2011) →