Use these procedures to troubleshoot the audio and visual system.
For vehicles equipped with an Extension Module, check the following contents for the radio and display receiver assembly and the Extension Module. (Refer to optional equipment's manuals)
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Measure the battery voltage with the ignition switch off.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.BASIC INSPECTION
Turn the ignition switch to ON.
Check whether or not the display appears on the display and audio and visual module display.
Result
Result
Proceed to
Display appears
A
Display does not appear
B
B.
A
4.CHECK FOR DTC
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs by simulating the operation indicated by the DTCs.