When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.
REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)
2.
DRAIN ENGINE COOLANT
NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug and the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
3.
DRAIN ENGINE OIL
Remove the oil filler cap.
Remove the oil drain plug, and drain the engine oil from the oil pan.