REASSEMBLY
Removal / installation · Vehicles built from Jun 2011
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Automatic Transmission, for 4WD) |
Attach the 7 claws to install the shifting hole cover.
| 2. INSTALL CONSOLE BOX BEZEL (for Manual Transmission, for 2WD) |
Attach the 8 claws to install the console box bezel.
Attach the 4 claws to install the shifting hole cover.
Install the 4 screws.
| 3. INSTALL REAR NO. 2 BOX PANEL (w/o Cup Holder) |
Attach the 2 claws and 2 guides to install the rear No. 2 panel box.
Install the 2 screws.
| 4. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY (w/ Cup Holder) |
Install the rear console end panel with the 4 screws.
| 5. INSTALL CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY |
Install the console compartment door with the 2 screws.
