2014 Hilux · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built from Jun 2011


1. REMOVE TAIL GATE SERVICE HOLE COVER

  1. B276661E01
    for A Deck:

    1. Remove the 10 screws and tail gate service hole cover.

  1. for J Deck:

    1. Remove the 8 screws and tail gate service hole cover.

      Text in Illustration 
      *A
      for A Deck
      *B
      for J Deck


2. REMOVE CENTER STOP LIGHT ASSEMBLY (w/ Center Stop Light)

B085010E01
  1. Disconnect the connector.

  1. Detach the 4 claws and remove the light.


3. REMOVE NO. 2 BACK DOOR GARNISH OUTSIDE (w/ Rear View Monitor System)

  1. E225235
    Disconnect the connector.

  1. E225233
    Push in the 2 claws of the back door No. 2 outside garnish to detach them.

  1. E225234
    Detach the 2 guides and claw as shown in the illustration and remove the back door No. 2 outside garnish.


4. REMOVE REAR TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)

  1. Detach the 2 claws and 2 guides as shown in the illustration and remove the rear television camera assembly.

    E226108


5. REMOVE TAIL GATE LOCK CONTROL LINK LH (for A Deck)

  1. B276662E01
    Rotate the control link snaps in the directions indicated by the arrows in the illustration and detach the control link snaps from the tail gate lock control link.
    Text in Illustration 
    *1
    Control Link Snap

  1. Remove the tail gate lock control link.


6. REMOVE TAIL GATE LOCK CONTROL LINK RH (for A Deck)

HINT:
Use the same procedure described for the LH side.


7. REMOVE TAIL GATE HANDLE ASSEMBLY (for A Deck)

  1. B276663
    Remove the 2 bolts and tail gate handle.


8. REMOVE TAIL GATE LOCK ASSEMBLY LH (for A Deck)

B276664
  1. Remove the 2 bolts and tail gate lock.


9. REMOVE TAIL GATE LOCK ASSEMBLY RH (for A Deck)

HINT:
Use the same procedure described for the LH side.


10. REMOVE TAIL GATE STAY STOPPER (for A Deck)

B276666

HINT:
Use the same procedure for both tail gate stay stoppers.

  1. Remove the bolt and tail gate stay stopper.


11. REMOVE REAR BODY TAIL GATE LATCH ASSEMBLY (for J Deck)

B276665

HINT:
Use the same procedure for both rear body tail gate latches.

  1. Remove the 2 bolts and rear body tail gate latch.


12. REMOVE TAIL GATE HINGE ASSEMBLY LH

B276668E01
  1. Using a T40 "TORX" socket wrench, remove the 2 "TORX" bolts.

  1. Remove the bolt and tail gate hinge.

    Text in Illustration 
    *1
    "TORX" Bolt
    *2
    Bolt


13. REMOVE TAIL GATE HINGE ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.

← REMOVAL (from Jun 2011)ADJUSTMENT (from Jun 2011) →