2014 Hilux · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Jun 2011 – Jul 2013

Versions by build date: Jun 2011 – Jul 2013 from Aug 2013

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY
(Click here)

2. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
(Click here)

3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
(Click here)

4. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

B278169E01
  1. Remove the 2 screws.

  1. Detach the 2 hooks in the order shown in the illustration and remove the front seat inner cushion shield LH.


5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

  1. B278171E01
    Raise the reclining adjuster release handle LH to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


6. REMOVE FRONT SEAT CUSHION SHIELD LH

B278172E01
  1. Remove the 2 screws.

  1. Detach the 2 hooks in the order shown in the illustration, and then detach the guide and remove the front seat cushion shield LH.

    Text in Illustration 
    *1
    Hook
    *2
    Guide


7. REMOVE SEATBACK SPRING LH

  1. B277649
    Remove the seatback spring LH.


8. REMOVE SEAT TRACK CONTROL CABLE BRACKET RH (for Walk in Seat Type)

B286625
  1. Using a screwdriver, remove the E-ring.

  1. Detach the hook and remove the seat track control cable bracket RH.


9. REMOVE SEAT TRACK CONTROL CABLE BRACKET LH (for Walk in Seat Type)

HINT:
Use the same procedure described for the RH side.


10. REMOVE FRONT SEATBACK HINGE PLATE (for Walk in Seat Type)

B286626
  1. Remove the front seatback hinge plate.


11. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

  1. for LHD, w/ Seat Heater System:

    1. B278177
      Remove the hog rings and fold back the separate type front seat cushion cover.

    2. B278537
      Disconnect the front seatback heater assembly LH connector.

  1. B111981E02
    Remove the 4 bolts and front seatback assembly.

  1. Detach the 2 pieces of fastening tape and remove the hog rings, and then roll up the separate type front seatback cover.

    B278173E01

    Text in Illustration 
    *1
    Fastening Tape
    -
    -

  1. B278174
    Remove the hog rings and detach the 2 straps of the separate type front seatback cover, and then roll up the separate type front seatback cover.

  1. B278175
    Pass the strap of the separate type front seatback cover through the holes of the separate type front seatback pad.

  1. Remove the hog rings and roll up the separate type front seatback cover.

    B286628E01

    Text in Illustration 
    *A
    for Vinyl Seat, for Cloth Seat
    *B
    for Leather Seat
    *a
    Front view of front seatback
    *b
    Rear view of front seatback

  1. B207089
    Detach the 4 claws and remove the 2 front seat headrest supports and separate type front seatback cover from the separate type front seatback pad.


12. REMOVE FRONT SEATBACK HEATER ASSEMBLY LH

  1. B284736
    Cut off the tack pins which hold down the front seatback heater assembly LH, and then remove the front seatback heater assembly LH from the separate type front seatback cover.

    NOTICE:
    Be careful not to damage the separate type front seatback cover.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →