Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM1840EF _51 Engine / Hybrid System _009574 2KD-FTV ENGINE MECHANICAL _0052170 REAR CRANKSHAFT OIL SEAL A

2KD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new rear crankshaft oil seal.


b.
A251991
1.875,1.24 1.552,1.573 true 2.167,1.208 1.813,1.573 1.813,1.573 1.208,1.573 false 0.854,1.458 1.177,1.625 0.323,0.167 10 false SST

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09518-36030  
09950-70010  (09951-07200)

NOTICE:
·

The acceptable depth from the top of the oil seal retainer is 0 to 0.8 mm (0 to 0.315 in.)

·

Keep the lip free from foreign matter.

·

Do not tap the oil seal at an angle.

·

Make sure that the oil seal is properly installed.




Hide 3.INSTALL CLUTCH DISC ASSEMBLY

Hide 4.INSTALL CLUTCH COVER ASSEMBLY

Hide 5.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

Hide 6.INSTALL MANUAL TRANSMISSION ASSEMBLY