When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the fuel inlet pipe, clean it with a brush and compressed air.
1.INSTALL FUEL SUPPLY PUMP ASSEMBLY
Check that the injection gear in the timing gear case moves back and forth smoothly.
Install a new O-ring to the fuel supply pump.
Apply a light coat of engine oil to the O-ring.
Align the groove of the injection gear with the set key on the drive shaft.
Install the fuel supply pump with the 2 nuts.
Set a new O-ring before tightening the set nut.
Using SST, hold the crankshaft pulley and install the set nut.
Install the pump drive shaft pulley and No. 2 camshaft timing pulley flange with the 4 bolts.
Move the pump drive shaft pulley back and forth to check the thrust clearance of the injection pump drive shaft.
0.15 to 0.55 mm (0.00590 to 0.0217 in.)
If the clearance is not within the specified range, disassemble and reassemble the fuel supply pump and pump drive shaft pulley. Then repeat the step above.
Connect the fuel temperature sensor connector and suction control valve connector.
Connect the 2 fuel hoses.
2.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
Temporarily install the fuel inlet pipe with the union nuts.
When replacing the fuel supply pump, it is necessary to replace the fuel inlet pipe with a new one.
Keep the fuel inlet pipe free of foreign matter.
Using a 17 mm union nut wrench, tighten the fuel inlet pipe union nut on the common rail side.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Using a 17 mm union nut wrench, tighten the fuel inlet pipe union nut on the fuel supply pump side.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE (w/ EGR Cooler)
4.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE (w/o EGR Cooler)
5.INSTALL TIMING BELT
6.INSTALL RADIATOR ASSEMBLY
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.ADD ENGINE COOLANT
9.BLEED AIR FROM FUEL SYSTEM
10.PERFORM FUEL SUPPLY PUMP INITIALIZATION
w/ EGR Cooler: (See page Engine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/ EGR Cooler)>INITIALIZATION)
w/o EGR Cooler: (See page Engine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM(w/o EGR Cooler)>INITIALIZATION)
11.INSPECT FOR COOLANT LEAK
12.INSPECT FOR FUEL LEAK