When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.INSTALL INTAKE MANIFOLD
Temporarily install a new gasket and the intake manifold with the 2 nuts and 4 bolts.
Tighten the 2 nuts and 4 bolts in the order shown in the illustration.
2.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
3.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
4.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
5.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY (w/ EGR System)
6.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY (w/ EGR System)
7.INSTALL INTAKE AIR CONNECTOR
Install a new gasket and the intake air connector with the 2 nuts and bolt.
8.INSTALL NO. 2 INTAKE AIR CONNECTOR BRACKET
Install the No. 2 intake air connector bracket with the 3 bolts.
9.INSTALL ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/ EGR System)
10.INSTALL VACUUM SWITCHING VALVE BRACKET (w/o EGR System)
Install the vacuum switching valve bracket with the 2 bolts.
11.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Install a new O-ring to the engine oil level dipstick guide.
Apply a small amount of clean engine oil to the O-ring.
Install the engine oil level dipstick guide with the bolt.
Install the injection pipe clamp with the bolt.
Install the engine oil level dipstick.
12.INSTALL MANIFOLD STAY
Install the manifold stay with the 2 bolts.
The manifold stay indented area (labeled A) must face the manifold.
13.INSTALL DIESEL THROTTLE BODY ASSEMBLY
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
15.BLEED AIR FROM FUEL SYSTEM
16.INSPECT FOR FUEL LEAK