When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
When replacing the common rail, do not remove the foreign object mixing prevention caps of the common rail until just before the fuel inlet pipe and injection pipe are connected to the common rail.
After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.
1.INSTALL COMMON RAIL ASSEMBLY
Install the common rail with the 2 bolts.
Connect the pressure discharge valve connector.
2.INSTALL VACUUM CONTROL VALVE SET (for i-ART)
| *1 | Paint Mark (White) |
| *2 | Paint Mark (Green) |
Install the vacuum control valve set with the 2 bolts.
Connect the 3 vacuum hoses and 2 vacuum switching valve connectors.
When connecting the hoses, match the colors of the paint marks on the hoses to the colors of the paint marks on the swirl control valve as shown in the illustration.
3.INSTALL OIL FILTER SUB-ASSEMBLY
4.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
5.INSTALL NO. 3 NOZZLE LEAKAGE PIPE
6.INSTALL NO. 2 FUEL PIPE
7.INSTALL WIRING HARNESS CLAMP BRACKET
8.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
9.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11.ADD ENGINE COOLANT
12.BLEED AIR FROM FUEL SYSTEM
13.INSPECT FOR COOLANT LEAK
14.INSPECT FOR FUEL LEAK
15.INSPECT FOR OIL LEAK
16.INSPECT ENGINE OIL LEVEL