1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
5.DISCONNECT NO. 2 FUEL HOSE
| *1 | No. 1 Fuel Hose |
| *2 | No. 2 Fuel Hose |
| *3 | Fuel Hose Connector Cover |
Disconnect the No. 2 fuel hose.
6.DISCONNECT NO. 1 FUEL HOSE
Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FBE FUEL>FUEL SYSTEM>PRECAUTION).
7.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Be careful not to drop the injectors when removing the delivery pipe.
Disconnect the 4 clamps and wire harness from the delivery pipe.
Disconnect the vacuum hose.
Disconnect the 4 injector connectors.
Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
Remove the 2 No. 1 delivery pipe spacers.
Remove the 4 injector vibration insulators.
Using 2 screwdrivers, pry out the 4 spacers from the cylinder head.
Tape the screwdriver tips before use.
Remove the 4 O-rings.
8.REMOVE FUEL INJECTOR ASSEMBLY
|
Pull |
Pull out the 4 fuel injectors from the delivery pipe.
Remove the 4 O-rings from the 4 fuel injectors.