Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL PRESSURE REGULATOR › 2012.01–2012.04
RM1840EF _51 Engine / Hybrid System _009581 2TR-FBE FUEL _0052254 FUEL PRESSURE REGULATOR A

2TR-FBE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.REMOVE FUEL PRESSURE REGULATOR

a.
A237743

Disconnect the vacuum hose.


b.

Disconnect the No. 2 fuel hose.

HINT:

Put a suitable container, cloth or equivalent under the fuel delivery pipe.



c.

Remove the 3 bolts and fuel pressure regulator.


d.

Remove the O-ring from the fuel pressure regulator.