Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL INJECTOR › from 2012.10
RM1840EF _51 Engine / Hybrid System _009582 1GR-FE FUEL _0052264 FUEL INJECTOR A

1GR-FE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.
A250899

Disconnect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 6.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

a.
A250900

Disconnect the No. 2 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 7.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

A075652

a.

Disconnect the 6 fuel injector connectors.


b.

Remove the 6 bolts and fuel delivery pipe together with the 6 fuel injectors.

NOTICE:

Be careful not to drop the injectors when removing the fuel delivery pipe.



Hide 8.REMOVE FUEL INJECTOR ASSEMBLY

A075653

a.

Pull out the 6 fuel injectors from the delivery pipe.


b.

Remove the O-ring and injector vibration insulator from each fuel injector.