Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › from 2012.10
RM1840EF _51 Engine / Hybrid System _009592 1GR-FE INTAKE / EXHAUST _0052355 INTAKE MANIFOLD A

1GR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 2.REMOVE NO. 2 ENGINE UNDER COVER

a.

Remove the 4 bolts and No. 2 engine under cover.


Hide 7.REMOVE INTAKE AIR SURGE TANK

a.
A076500

Disconnect the No. 4 water by-pass hose.


b.

Disconnect the No. 5 water by-pass hose.


c.
A251407

Disconnect the purge line hose.


d.

Disconnect the vacuum hose.


e.
A075645

Disconnect the No. 1 PCV hose.


f.
A253781

Disconnect the purge VSV connector.


g.

Disconnect the vacuum switching valve (for ACIS) connector.


h.

Disconnect the throttle body connector.


i.

Detach the 3 wire harness clamps and disconnect the wire harness.


j.
A076501

Remove the 2 bolts and throttle body bracket.


k.
A076502

Remove the bolt and oil baffle plate.


l.

Remove the 2 bolts and No. 1 surge tank stay.


m.

Remove the 2 bolts and No. 2 surge tank stay.


n.
A253782

Remove the 2 bolts and disconnect the water hose sub-assembly.


o.
A251370
1.25,1.167 1.292,1.125 false
V100135

Bolt
V100136

Nut


Using an 8 mm hexagon wrench, remove the 4 bolts, 2 nuts, intake air surge tank and gasket.


Hide 8.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 9.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 10.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 11.REMOVE INTAKE MANIFOLD

a.
A251371

Remove the 10 bolts, intake manifold and 2 gaskets.


Hide 12.REMOVE STUD BOLT

HINT:

If a stud bolt is deformed or its threads are damaged, replace it.


a.

Using an E7 "TORX" socket wrench, remove the stud bolts.