Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PRESSURE REGULATOR › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009582 1GR-FE FUEL _0052265 FUEL PRESSURE REGULATOR A

1GR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.

Disconnect the vacuum hose.


b.
A133700

Remove the 2 bolts and fuel pressure regulator.


c.

Remove the O-ring from the fuel pressure regulator.