Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL PRESSURE PULSATION DAMPER › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009582 1GR-FE FUEL _0052266 FUEL PRESSURE PULSATION DAMPER A

1GR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.

Apply a light coat of spindle oil or gasoline to a new O-ring and install it onto the fuel pressure pulsation damper.


b.

Install the fuel pressure pulsation damper to the fuel delivery pipe.


c.

Install the fuel pressure regulator holder.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).