Home › Engine / Hybrid System › 1GR-FE FUEL › FUEL FILTER › 2012.04–2012.10
RM1840EF _51 Engine / Hybrid System _009582 1GR-FE FUEL _0052267 FUEL FILTER A

1GR-FE FUEL  FUEL FILTER  REPLACEMENT  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.DISCONNECT CHARCOAL CANISTER ASSEMBLY

Hide 5.DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.
A250904

Detach the No. 1 fuel pipe from the fuel filter.


b.

Disconnect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 6.DISCONNECT FUEL MAIN TUBE

a.
A250905

Remove the fuel main tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 7.REMOVE FUEL FILTER

a.
A075660

Remove the 3 nuts and fuel filter.


Hide 8.INSTALL FUEL FILTER

a.

Install the fuel filter with the 3 nuts.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 9.CONNECT FUEL MAIN TUBE

a.

Connect the fuel main tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 10.CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY

a.

Connect the No. 1 fuel pipe (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).


b.

Attach the No. 1 fuel pipe to the fuel filter.


Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).