1.INSTALL FUEL TANK TO FILLER PIPE HOSE
Install the fuel tank to filler pipe hose to the fuel tank.
2.INSTALL FUEL TANK BREATHER HOSE
Install the fuel tank breather hose to the fuel tank.
3.INSTALL NO. 2 FUEL TANK PROTECTOR
Attach the 2 claws and install the protector.
4.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
5.INSTALL FUEL PUMP GAUGE RETAINER
6.INSTALL NO. 2 FUEL TANK CUSHION
Install a new No. 2 fuel tank cushion.
7.INSTALL NO. 1 FUEL TANK CUSHION
Install a new No. 1 fuel tank cushions.
Install the clip to the cushion on the front side.
Install only 1 clip so that the cushion can be folded back and the wire harness can be installed when the fuel tank assembly is installed to the vehicle.
8.INSTALL NO. 1 FUEL TANK HEAT INSULATOR
Install the No. 1 fuel tank heat insulator with the 4 new clips and nut.
9.INSTALL FUEL TANK ASSEMBLY
Set the fuel tank on a engine lifter and lift up the engine lifter.
| *1 | Clip | *2 | Fuel Tank Cushion |
| *3 | Wire Harness | *4 | Fuel Tank |
Do not allow the fuel tank to contact the vehicle, especially the differential.
Be careful not to cut the wiring.
Fold back the 2 cushion rubbers.
Connect the 6 harness clips and fuel pump connector to the fuel tank.
Install the cushion rubber on the front side with the remaining clip.
Install the 2 No. 1 fuel tank bands with the 2 pipes and 2 clips.
Connect the 2 No. 1 fuel tank bands with the 2 bolts.
10.INSTALL FUEL TANK FILLER PIPE
Install the fuel tank filler pipe with the bolt.
11.CONNECT FUEL TANK TO FILLER PIPE HOSE
Connect the filler pipe hose to the fuel tank filler pipe.
12.CONNECT FUEL TANK BREATHER HOSE
Connect the fuel tank breather hose to the fuel tank filler pipe.
13.CONNECT FUEL MAIN TUBE AND FUEL RETURN TUBE
Before installing the tube connectors to the pipes, check the connectors for damage and foreign matter.
Connect the fuel main tube and fuel return tube (See page Engine / Hybrid System>1GR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Connect the vent line hose.
14.INSTALL NO. 3 FUEL TUBE CLAMP
Install the No. 3 fuel tube clamp to the fuel tube.
15.INSTALL FUEL TANK CAP ASSEMBLY
16.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
17.INSPECT FOR FUEL LEAK