When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes and fuel inlet pipe, clean them with a brush and compressed air.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE DIESEL THROTTLE BODY ASSEMBLY (w/ EGR Cooler)
4.REMOVE NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)
5.REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)
6.DRAIN ENGINE COOLANT (w/ EGR Cooler)
7.DRAIN ENGINE OIL
8.REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY (w/o EGR Cooler)
9.REMOVE MANIFOLD STAY WITH VACUUM SWITCHING VALVE (w/ EGR Cooler)
10.REMOVE MANIFOLD STAY (w/o EGR Cooler)
11.REMOVE OIL FILTER SUB-ASSEMBLY
12.DISCONNECT NO. 3 WATER BY-PASS HOSE (w/ EGR Cooler)
13.DISCONNECT NO. 4 WATER BY-PASS HOSE (w/ EGR Cooler)
14.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
15.REMOVE NO. 2 INTAKE AIR CONNECTOR BRACKET (w/ EGR Cooler)
16.DISCONNECT NO. 3 WATER BY-PASS PIPE (w/ EGR Cooler)
17.REMOVE ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (w/ EGR Cooler)
18.REMOVE NO. 2 INTAKE AIR CONNECTOR (w/ EGR Cooler)
19.REMOVE INTAKE AIR CONNECTOR (w/ EGR Cooler)
20.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER (w/ EGR Cooler)
21.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
22.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
Disconnect the 3 fuel hoses.
| *A | w/ EGR Cooler |
| *B | w/o EGR Cooler |
| *1 | Union Bolt |
Remove the union bolt, 3 bolts, No. 2 nozzle leakage pipe and gasket.
23.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE (w/ EGR Cooler)
24.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE (w/o EGR Cooler)
25.REMOVE FUEL INLET PIPE SUB-ASSEMBLY
26.REMOVE COMMON RAIL ASSEMBLY
Do not remove the pressure discharge valve or fuel pressure sensor.
Disconnect the 2 connectors.
w/ EGR Cooler:
Remove the 2 bolts, common rail and No. 2 intake manifold insulator.
w/o EGR Cooler:
Remove the 2 bolts and common rail.