Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST PIPE › from 2012.04
RM1840EF _51 Engine / Hybrid System _009592 1GR-FE INTAKE / EXHAUST _0052358 EXHAUST PIPE A

1GR-FE INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.

Connect the front exhaust pipe to the exhaust pipe support.


b.

Install a new gasket.


c.

Install the front exhaust pipe with the 2 new nuts.

Torque:
54 N*m (554 kgf*cm, 40 ft.*lbf)


Hide 2.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY

a.

Connect the front No. 2 exhaust pipe to the exhaust pipe support.


b.

Install 2 new gaskets.

NOTICE:

Do not reuse the gaskets.



c.

Install the front No. 2 exhaust pipe with 2 new nuts to the exhaust manifold.

Torque:
54 N*m (554 kgf*cm, 40 ft.*lbf)


d.

Connect the front No. 2 exhaust pipe with the 2 bolts and 2 new nuts to the front No. 2 exhaust pipe.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)


Hide 3.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.
A111834

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

40.5 mm (1.59 in.)


If the free length is less than the minimum, replace the compression spring.


b.
A111803
3.021,0.958 3.021,1.51 true 2.938,1.594 3.115,1.802 0.177,0.208 10 false *1
*1 Gasket


Install a new gasket to the front exhaust pipe.

NOTICE:
·

Be sure to install the gasket so that it faces the correct direction.


·

Do not reuse the gasket.


·

When connecting the exhaust pipe, do not push in the gasket with the exhaust pipe.



HINT:

Using a plastic-faced hammer, uniformly tap the gasket so that the gasket and front exhaust pipe fit properly.



c.

Connect the center exhaust pipe to the 3 exhaust pipe supports.


d.

Install the exhaust pipe and 2 springs with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 4.INSTALL TAILPIPE ASSEMBLY

a.

Install a new gasket.

NOTICE:

Do not reuse the gasket.



b.

Connect the tailpipe to the exhaust pipe support.


c.

Install the tailpipe with the 2 bolts.

Torque:
48 N*m (489 kgf*cm, 35 ft.*lbf)


Hide 5.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 6.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)