1.INSTALL THERMOSTAT
| *1 | Gasket |
| *2 | Jiggle Valve |
| *a | CORRECT |
| *b | INCORRECT |
|
Upward |
Install a new gasket to the thermostat.
When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.
Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.
The jiggle valve may be set within 30° of either side of the prescribed position.
2.INSTALL WATER INLET
Install the wire harness clamp bracket to the water inlet with the bolt.
Install the water inlet with the 3 bolts.
Connect the wire harness clamp.
3.CONNECT RADIATOR HOSE OUTLET
Connect the radiator hose outlet to the water inlet.
4.CONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission)
Connect the No. 1 automatic transmission oil cooler tube clamp to the water inlet with the bolt.
5.INSTALL COMPRESSOR INLET ELBOW
6.INSTALL VENTILATION PIPE
7.INSTALL AIR CLEANER ASSEMBLY
8.ADD ENGINE COOLANT
9.INSPECT FOR COOLANT LEAK
10.INSTALL INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR
11.INSTALL NO. 1 ENGINE UNDER COVER