1.INSTALL RADIATOR ASSEMBLY
Install the radiator with the 4 bolts.
Attach the 4 clamps of the 2 front airbag sensors to the radiator.
Connect the 2 front airbag sensor front connectors.
2.INSTALL FAN SHROUD
Install the fan pulley to the water pump.
Place the shroud together with the coupling fan between the radiator and engine.
Be careful not to damage the radiator core.
Install the fluid coupling fan to the water pump with the 4 nuts. Tighten the nuts as much as possible by hand.
Attach the shroud's claws to the radiator as shown in the illustration.
Install the shroud with the 2 bolts.
Connect the reservoir hose to the radiator tank upper.
Install the fan and generator V belt (See page Engine / Hybrid System>1GR-FE ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).
Tighten the 4 nuts of the fluid coupling fan.
Install the oil reservoir with the 3 bolts.
3.CONNECT OIL COOLER INLET HOSE
Connect the oil cooler inlet hose to the radiator tank lower.
4.CONNECT OIL COOLER OUTLET HOSE
Connect the oil cooler outlet hose to the radiator tank lower.
5.CONNECT RADIATOR HOSE INLET
Connect the radiator hose inlet to the radiator.
6.CONNECT RADIATOR HOSE OUTLET
Connect the radiator hose outlet to the radiator.
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8.ADD ENGINE COOLANT
9.INSPECT FOR COOLANT LEAK
10.INSTALL RADIATOR SIDE DEFLECTOR RH
Install the deflector with the 2 clips and attach the claw.
11.INSTALL RADIATOR SIDE DEFLECTOR LH
Install the deflector with the 2 clips and attach the claw.
12.INSTALL RADIATOR GRILLE
13.INSTALL NO. 1 ENGINE UNDER COVER
14.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH
15.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH