Home › Engine / Hybrid System › 2TR-FBE LUBRICATION › LUBRICATION SYSTEM
RM1840EF _51 Engine / Hybrid System _009601 2TR-FBE LUBRICATION _0052404 LUBRICATION SYSTEM G

2TR-FBE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the oil and oil filter (See page Engine / Hybrid System>2TR-FBE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT).


Hide 2.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine, and then stop the engine and wait for 5 minutes.

If the oil level is low, check for leakage and add oil up to the full level mark.


b.

Check that the engine oil level is between the low level and full level marks on the dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 3.INSPECT OIL PRESSURE

a.

Remove the engine oil pressure switch (See page Engine / Hybrid System>2TR-FBE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL).


b.
A222343
0.396,1.24 0.5,1.24 0.5,1.24 0.792,0.573 true 0.219,1.146 0.396,1.323 0.177,0.177 10 false *1
*1 Oil Pressure Gauge


Install an oil pressure gauge.


c.

Warm up the engine.


d.

Check the oil pressure under the following conditions.

Standard Oil Pressure:
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)


If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>2TR-FBE LUBRICATION>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.


f.

Install the engine oil pressure switch (See page Engine / Hybrid System>2TR-FBE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION).