Home › Engine / Hybrid System › 1GR-FE LUBRICATION › LUBRICATION SYSTEM › from 2012.04
RM1840EF _51 Engine / Hybrid System _009602 1GR-FE LUBRICATION _0052408 LUBRICATION SYSTEM G

1GR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the oil and oil filter (See page Engine / Hybrid System>1GR-FE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT).


Hide 2.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, and then stop the engine and wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 3.INSPECT OIL PRESSURE

a.

Remove the engine oil pressure switch (See page Engine / Hybrid System>1GR-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL).


b.
A075904
1.219,0.448 0.875,0.448 false 1.281,0.344 1.458,0.542 0.177,0.198 10 false *1
*1 Oil Pressure Gauge


Install an oil pressure gauge.


c.

Warm up the engine.


d.

Inspect the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)


If the pressure is not as specified, check the oil pump (See page Engine / Hybrid System>1GR-FE LUBRICATION>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.


f.

Install the engine oil pressure switch (See page Engine / Hybrid System>1GR-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION).