1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE FRONT CONSOLE BOX
4.REMOVE SHIFT LEVER BOOT ASSEMBLY
Remove the 4 screws and shift lever boot assembly.
5.REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY
Fold back the transfer front drive shift boot.
Using needle-nose pliers, remove the snap ring and pull out the shift lever.
Move the transfer shift lever to the H4 position.
6.REMOVE NO. 1 ENGINE UNDER COVER
7.REMOVE NO. 2 ENGINE UNDER COVER
8.REMOVE FRONT EXHAUST PIPE ASSEMBLY
9.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
10.REMOVE PROPELLER SHAFT ASSEMBLY
11.DRAIN AUTOMATIC TRANSMISSION FLUID
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
12.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY
Remove the oil dipstick.
Remove the 2 bolts and oil filler tube.
Remove the O-ring from the oil filler tube.
13.DISCONNECT OIL COOLER TUBE
Using a union nut wrench, disconnect the inlet tube and outlet tube.
Remove the 3 bolts and 3 clamps.
14.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the nut and disconnect the control cable.
Remove the clip and disconnect the control cable.
15.DISCONNECT GROUND CABLE
Remove the nut and disconnect the ground cable.
16.REMOVE STARTER ASSEMBLY
17.SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY
Support the transmission with a transmission jack.
18.REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Remove the 4 set bolts of the No. 1 engine mounting insulator rear.
Remove the 4 nuts, 4 bolts and frame crossmember.
19.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR
Remove the 4 bolts and engine mounting insulator.
20.DISCONNECT ENGINE WIRE
Tilt the transmission downward.
Make sure the cooling fan does not contact the fan shroud.
Disconnect the 5 connectors and detach the 6 clamps.
| *A | LH Side | *B | RH Side |
Disconnect the 5 connectors.
21.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket from the transmission.
22.REMOVE STIFFENER PLATE
Remove the 4 bolts and stiffener plate RH (with clamp).
| *A | LH Side | *B | RH Side |
Remove the 4 bolts and stiffener plate LH.
Remove the No. 4 cylinder block insulator.
Remove the No. 2 end plate.
23.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
Turn the crankshaft to gain access to each bolt.
Hold the crankshaft pulley bolt with a wrench, and remove the 6 torque converter clutch mounting bolts.
| *1 | Knock Pin |
Remove the 5 bolts and transmission from the engine.
To prevent damage to the knock pins, do not pry between the automatic transmission assembly and engine assembly.
24.REMOVE TRANSMISSION CONTROL CABLE BRACKET
Remove the 2 bolts and control cable bracket from the transmission.
25.REMOVE TRANSFER ASSEMBLY
26.REMOVE TORQUE CONVERTER ASSEMBLY