Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052565 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Clean the contact surfaces of the differential carrier and axle housing.

NOTICE:

Be careful not to damage the installation surface.



b.

Install the differential carrier, and a new gasket and the washers with the 10 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Be careful to install the gasket without tearing it.



Hide 2.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

Hide 3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described described for the LH side.


Hide 7.ADJUST PARKING BRAKE