Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.REMOVE REAR BRAKE
for 2WD:
for 4WD and Pre-Runner:
(See page Brake>BRAKE (REAR)>REAR BRAKE(for 4WD and Pre-Runner)>REMOVAL)
3.REMOVE REAR SPEED SENSOR LH (w/ ABS)
4.DISCONNECT PARKING BRAKE CABLE
Remove the 2 bolts and disconnect the parking brake cable.
5.REMOVE REAR AXLE SHAFT WITH BACKING PLATE
Remove the 4 nuts.
Pull out the axle shaft from the axle housing.
6.REMOVE O-RING
Remove the O-ring from the axle housing.
7.REMOVE REAR AXLE SHAFT OIL SEAL LH
Using SST, tap out the oil seal.
Be careful not to damage the axle housing hole.