Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR › 2012.01–2012.04
RM1840EF _54 Brake _009623 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0052595 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR SPEED SENSOR

a.

Install the speed sensor RH with the bolt.

C225637

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.




b.

Install the harness clamp with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

When installing the clamp, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




c.

Attach the 2 clamps.

NOTICE:

When attaching the clamps, do not twist the wire harness.



d.

Attach the connector.

NOTICE:
·

Securely attach the connector.

·

When attaching the connector, do not twist the wire harness.




e.

Connect the connector.

NOTICE:
·

Securely connect the connector.

·

When connecting the connector, do not twist the wire harness.




f.

Install the speed sensor LH with the bolt.

C225638
3.24,2.094 3.365,2.24 0.125,0.146 10 A 6.021,2.521 6.146,2.667 0.125,0.146 10 B

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

·

While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

·

After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.




g.

Install the 2 harness clamps with the 2 bolts.

Torque:
for bolt A : 8.5 N*m (87 kgf*cm, 75 in.*lbf)
for bolt B : 32 N*m (326 kgf*cm, 24 ft.*lbf)

NOTICE:
·

When installing the clamps, do not twist the wire harness.

·

Make sure the clamp rotation stopper touches the installation position.




h.

Attach the clamp.

NOTICE:

When attaching the clamp, do not twist the wire harness.



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).