DTC C1283/83 is output only in Test Mode.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1283/83 | L4 Position Switch Malfunction (Test Mode DTC) | No signal is input to the EXI4 terminal of the skid control ECU. | ·
L4 position switch (No. 1 transfer indicator switch) ·
EXI4 terminal circuit ·
Skid control ECU (Brake actuator assembly) |
*C1283/83: for 4WD
The codes in this table are output only in Test Mode.
Before disconnecting the connector, make sure that there are no problems with the connection.
After disconnecting the connector, make sure that the connector case and terminals are not deformed or corroded.
Set the vehicle to the L4 state using the transfer shift lever.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-3 (EXI4) - Body ground | Transfer shift position L4 | Below 1 Ω |
Connect the skid control ECU (brake actuator assembly) connector.
Set the vehicle to the H2 state using the transfer shift lever.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-3 (EXI4) - Body ground | Transfer shift position H2 | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Switch the vehicle to Test Mode, perform the H2 to L4 shift operation check, and then check that DTC C1283/83 is not stored.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE
| Result | Proceed to |
|---|---|
| DTC is stored | A |
| DTC is not stored | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Disconnect the L4 position switch (No. 1 transfer indicator switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A13-3 (EXI4) - C29-1 | Always | Below 1 Ω |
| A13-3 (EXI4) - Body ground | Always | 10 kΩ or higher |
| C29-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Remove the L4 position switch (No. 1 transfer indicator switch).
Click hereDrivetrain>VF2A TRANSFER / 4WD / AWD>TRANSFER INDICATOR SWITCH>REMOVAL
Inspect the L4 position switch (No. 1 transfer indicator switch).
Click hereDrivetrain>VF2A TRANSFER / 4WD / AWD>TRANSFER INDICATOR SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG