Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER(w/ VSC) › from 2012.01
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052609 BRAKE MASTER CYLINDER(w/ VSC) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new O-ring to the brake master cylinder sub-assembly.


b.

Install the master cylinder and brake tube way to the brake booster with the 2 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Using a union nut wrench, connect the 4 brake lines to the brake master cylinder and brake tube way.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector to the master cylinder.


e.

for Manual Transmission:

Connect the clutch reservoir tube to the master cylinder reservoir.


Hide 4.BLEED CLUTCH LINE (for Manual Transmission)