Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(w/ VSC) › 2011.10–2012.01
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052611 BRAKE BOOSTER(w/ VSC) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Install a new gasket to the brake booster.


b.

Install the booster with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


c.

Install the push rod clevis.


d.

Apply a light coat of lithium soap base glycol grease to the clevis pin.


e.
C226774C01
1.031,2.417 1.031,1.646 1.031,1.646 0.802,1.646 true 1.958,0.802 1.427,0.26 1.427,0.26 1.177,0.26 true 2,1.896 2,2.75 2,2.75 2.375,2.75 true 0.948,0.156 1.219,0.365 0.271,0.208 10 false *1 0.583,1.563 0.844,1.75 0.26,0.188 10 false *3 2.458,2.656 2.74,2.885 0.281,0.229 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Install the clevis pin and a new clip.

NOTICE:

The clip must be installed as shown in the illustration.



f.

Install the return spring.


g.

Install the vacuum check valve grommet and vacuum check valve to the brake booster.


h.

Connect the vacuum hose.


i.

Install the vacuum warning switch grommet to the brake booster.


j.

Install the vacuum warning switch to the brake booster and connect the vacuum warning switch connector.


Hide 2.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 5.BLEED CLUTCH LINE (for Manual Transmission)

Hide 6.CHECK AND ADJUST BRAKE PEDAL HEIGHT