Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1KD-FTV, 2KD-FTV)
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052613 VACUUM PUMP(for 1KD-FTV, 2KD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1KD-FTV, 2KD-FTV)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL VACUUM PUMP BEARING

a.
C111354

Using a press, press in a new bearing to the shaft.


Hide 2.INSTALL VACUUM PUMP SHAFT

a.
C111355
1.5,0.698 0.865,0.698 true 0.49,0.604 0.813,0.771 0.323,0.167 10 false SST

Using SST and a press, press in the shaft to the housing.

SST
09608-04031  


b.

Using snap ring pliers, install a new snap ring.

NOTICE:

Make sure that the snap ring is firmly installed to the groove.



Hide 3.INSTALL VACUUM PUMP GEAR

a.

Temporarily install the woodruff key and gear to the pump with the gear lock nut.


b.

Mount the gear in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the gear.



c.

Tighten the gear lock nut.

Torque:
110 N*m (1125 kgf*cm, 81 ft.*lbf)


Hide 4.INSTALL VACUUM PUMP BLADE

a.
C111356
0.4,0.208 0.557,0.357 0.157,0.149 10 *a
*a Round End


Apply engine oil to the rotor, and install the rotor to the housing.


b.

Install 5 new blades with the round ends facing outward.

HINT:
·

Apply engine oil to the blades.

·

Make sure that the blades are flush with the rotor surface.




Hide 5.INSTALL VACUUM PUMP END COVER

a.

Mount the pump in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the pump.



b.

Apply engine oil to 2 new O-rings.


c.

Install the 2 O-rings.


d.

Install the end cover and temporarily install the 3 bolts.


e.

Using a 5 mm pin punch and hammer, tap in the 2 straight pins.


f.

Tighten the 3 bolts.

Torque:
7.9 N*m (80 kgf*cm, 69 in.*lbf)


Hide 6.INSTALL CHECK VALVE SUB-ASSEMBLY

a.

Install a new gasket and the check valve.

Torque:
74 N*m (749 kgf*cm, 54 ft.*lbf)


b.

Install 2 new gaskets and the union with the union bolt.

Torque:
14 N*m (140 kgf*cm, 10 ft.*lbf)

HINT:

Insert the union pin into the hole of the casing.



Hide 7.INSTALL VACUUM PUMP ASSEMBLY

a.

Install 2 new O-rings.


b.

Install the pump to the engine with the 2 nuts.

Torque:
21 N*m (210 kgf*cm, 15 ft.*lbf)


c.

Connect the 2 hoses to the pump with the clip.


Hide 10.REMOVE RADIATOR ASSEMBLY