Home › Brake › BRAKE SYSTEM (OTHER) › LOAD SENSING PROPORTIONING VALVE(w/o VSC) › from 2012.04
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052615 LOAD SENSING PROPORTIONING VALVE(w/o VSC) A

BRAKE SYSTEM (OTHER)  LOAD SENSING PROPORTIONING VALVE(w/o VSC)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL LOAD SENSING SPRING BUSH & BOOT KIT

a.

Install the load sensing valve boot and load sensing spring boot to the spring.


b.

Install the 2 dust seals, 2 collars and 2 No. 1 load sensing spring bushes and 2 No. 2 load sensing spring bushes to the load sensing spring assembly.

NOTICE:
·

Apply lithium soap base glycol grease to all contact surfaces.

·

Make sure the valve side and shackle side of the spring are installed properly.




Hide 2.INSTALL NO. 1 AND NO. 2 SHACKLES

a.

Install the adjusting nut and No. 2 shackle to the No. 1 shackle.


b.

Tighten the lock nut.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Install the No. 1 shackle (with the No. 2 shackle) to the spring.


d.

Install the 2 plate washers and spring washer with the bolt and nut.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 3.INSTALL LOAD SENSING SPRING ASSEMBLY

a.

Using pliers, install the spring to the valve body with the clip.


Hide 4.INSTALL LOAD SENSING VALVE BRACKET

a.

Install the load sensing valve bracket to the valve with the nut and bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 5.INSTALL REAR FLEXIBLE HOSE BRACKET

a.

Install the bracket and valve set plate to the valve 2 spring washer with the 2 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


b.

Install a new clip.


c.

Using a union nut wench, connect the No. 6 brake tube to the rear brake flexible hose.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 6.INSTALL LOAD SENSING PROPORTIONING VALVE ASSEMBLY

a.

Install the valve with the 3 bolts.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)


b.

Using a union nut wrench, connect the 3 brake lines to the valve body.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 7.CONNECT NO. 2 LOAD SENSING SPRING SHACKLE

a.

Connect the No. 2 shackle to the rear differential.


b.

Install the bolt, collar and 2 load sensing valve bushes.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)


Hide 12.BLEED CLUTCH LINE (for Manual Transmission)