Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for TSAM Made) › from 2012.04
RM1840EF _54 Brake _009624 BRAKE SYSTEM (OTHER) _0052623 BRAKE BOOSTER(for TSAM Made) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for TSAM Made)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.

HINT:

Tighten the lock nut after adjusting the brake pedal height.



b.

Install a new gasket to the brake booster.


c.

Install the booster with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


d.

Install the push rod clevis to the brake booster.


e.

Apply a light coat of lithium soap base glycol grease to the clevis pin.


f.
C226773C05
1.031,2.417 1.031,2.208 1.031,2.208 0.771,2.208 false 1.948,1.208 1.302,0.802 1.302,0.802 1.177,0.802 false 2.177,1.99 2.177,2.781 2.177,2.781 2.281,2.781 true 1,0.708 1.24,0.896 0.24,0.188 10 false *1 0.594,2.115 0.813,2.302 0.219,0.188 10 false *3 2.344,2.688 2.615,2.844 0.271,0.156 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Install the clevis pin and a new clip.

NOTICE:

The clip must be installed as shown in the illustration.



g.

Install the return spring.


h.

Install a new grommet and check valve to the booster.


i.

Connect the vacuum hose.


j.

Install the vacuum warning switch to the booster and connect the vacuum warning switch connector.

Torque:
14 N*m (139 kgf*cm, 10 ft.*lbf)


Hide 3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 5.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)

Hide 6.CHECK AND ADJUST BRAKE PEDAL HEIGHT