Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner) › from 2012.04
RM1840EF _54 Brake _009625 BRAKE (FRONT) _0052626 FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner) A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedures listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT NO. 1 WHEEL CYLINDER TUBE LH

a.

Using a union nut wrench, install the wheel cylinder tube to the brake cylinder.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the wheel cylinder tube.

·

Do not allow any foreign matter such as dirt and dust to enter the wheel cylinder tube from the connecting points.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 2.INSTALL FRONT FLEXIBLE HOSE

a.

Attach 2 new clips to the flexible hose.


b.

Using a union nut wrench, connect the flexible hose to the brake tube and wheel cylinder tube while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake tube and wheel cylinder tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




Hide 8.BLEED CLUTCH LINE (for Manual Transmission)